LEESONis
a leading designer and manufacturer of application-specific
AC and DC motors and gearmotors. Often, this involves collaboration
among our application, design and production engineers, and
our customer’s product engineers. Our interactive Design
Center at our Grafton, Wisconsin headquarters is ideally suited
for this purpose. What you see below is a small sampling of
the thousands of custom solutions LEESON has produced over
the years. Quick-turnaround stock motor modifications are
available through the LEESON Mod-Squad™.
Low-voltage
DC traction drive gearmotor for a disabled mobility vehicle.
Tru-Torq
low voltage DC motor with special mounting bracket and
screw shaft.
Tru-Torq
SCR-rated DC motor with quick connect and special flange
mount.
Low-voltage
DC NEMA 56 C face brakemotor with manual brake release.
Construction
industry motor with on/off switch, "low-high"
voltage change feature and water pump power supply connection.
DC
SCR rated motor with spline shaft, needle bearings, and
one-half of gear pump for airless spray equipment.
Special
DC SCR rated motor with hollow, tapered and threaded
shaft and chemically resistant paint finish for laboratory
pumping equipment.
Metric
flanged (B14) motor for close-coupling of European gear
reducer.
Partial
hoist drive motor with special diameter rabbet and slotted
shaft.
Parallel-shaft
low voltage DC gearmotor with threaded shaft for portable
reverse-osmosis water-purification systems.
Woodworking
machinery motor with built-in power supply cord and
on/off switch.
Time-rated,
maximum HP, three phase hydraulic pump motor with close-coupled
mounting of the pump
